* If you will get dial tone with "9" while entering phone numbers, please press
"9" then press "0" long to get dial tone and press "05321234567" and then "√".
On LCD keypad (By using up and down arrow keys)
Enter BASIC SETTINGS"√"→PRIVATE PHONES"√"→01-PERSON PHONE
NR, press "05321234567" and then "√" button.
* For entering other user phone number, follow and do the same steps using
"0602"..."0608" addresses on LED keypad or "...→02-PERSON PHONE NR"...
"...→08-PERSON PHONE NR" menu on LCD keypad.
* If you will get dial tone with "9" while entering phone numbers, please press
"9" then press "0" long to get dial tone and press "05321234567" and then "√".
Note: When any user phone number is entered, user phone dialing will be activated
automatically.
6. For exiting Installer Program
Press "x" (Exit) button until you hear long "beep" sound. Program LED will turn
OFF on LED keypad and The Main Messages will be displayed on LCD keypad if
you exit the program successfully.
6.1.2 Entering Master Program
a) Press long to 4 (program) button until you hear long "beep" sound.
b) Enter 4 numbered master code. (Factory value: 1234)
If you entered the master program successfully, Program LED will be blinking
on LED keypad or "MASTER MENU" message will be displayed on LCD
keypad. If not, press "x" (Exit) button first and then try again.
In master program;
You can assign user codes in master code. 29 user codes (+1 guest code) can be
assigned except installer and master code. The passwords are recommended to
change for the system safety.
1. For assigning user codes.
On VPC 116/132 LED keypad
After you pressed "0701", enter 4 digit code and then "√" button. This 4 digit
code will be 1.user code.
* For assigning other user codes, please use "0702"..."0729" addresses on LED
keypad or "...→02-USER CODE"..."...→29-USER CODE" menu on LCD
keypad. Also use "0730" address on LED keypad and "...→30-USER CODE"
menu on LCD keypad for assigning guest code.
On LCD keypad (By using up and down arrow keys)
Enter BASIC SETTINGS"√"→USER CODES"√"→01-USER CODE, enter 4 digit
code and then "√" button.
* For assigning other user codes, please use "0702"..."0729" addresses on LED
keypad or "...→02-USER CODE"..."...→29-USER CODE" menu on LCD
keypad. Also use "0730" address on LED keypad and "...→30-USER CODE"
menu on LCD keypad for assigning guest code.
2. For assigning duress code.
On VPC 116/132 LED keypad
After you pressed "0731", enter 4 digit code and then "√" button. This 4 digit
code will be duress code.
On LCD keypad (By using up and down arrow keys)
Enter BASIC SETTINGS"√"→USER CODES"√"→31-USER CODE, enter 4 digit
code and then "√" button.
3. For changing PC Remote Access code. (Factory value: 7777)
To Next Page
Loading...
