Factory default: Empty
8.1.7. To Set / Make User Codes
It is only possible to reach the code addresses by the master program. By defining
the code on the relevant address, that person is also defined. When writing "0000" on
any code address, that user is deleted. The Master and Installer codes do not have
any address and they can not be deleted.
!!! WARNING !!!
Any of the code numbers which were used earlier (Master, Installer, Duress, Guest
and PC Access etc) as code, cannot be made as a code for other user again. The
panel gives error message if there is any process to make such code
It is important to remark that the password given here is temporary and the user can
change the password by pressing "√" (Password) long, and entering the 4 digits old
password, entering the 4 digits new password and entering the 4 digits new
password again and pressing the "√" (Password) button, when the control panel is
normal.
Example:
Let us change the Master code from "1234" factory setting to "9876".
"√" (press long) 1234 9876 9876 "√"
old new new again
1
st
User Code
Address 07 01.< MP >
Change for settings:
LED 07 01 <code> "√"
LCD BASIC SETTINGS→USER CODES→01-USER CODE
<code> "√"
Entered Value: <code>, 4 digit numbers. If entering "0000", the user will be
cancelled.
Factory default: 0000=User is not defined.
Special Case: Codes can not be seen.
Example: To make the 1
st
user code as 5784.
07 01 5 7 8 4 √
2...29 User Code
Address 07 02...27. < MP >
Factory default: 0000=User is not defined.
8.1.7.1. To Set/Make Guest Code
Address 07 30.< MP >
Change for settings:
LED 07 30 <Code> "√"
LCD BASIC SETTINGS→USER CODES→30-USER CODE
<Code> "√"
Entered Value: <code>, 4 digit numbers. If entering "0000", the user will be
cancelled.
Factory default: 0000=User is not defined.
Special Case: Codes can not be seen.
Example: To make the guest code as 5784.
07 30 5 7 8 4 √
To Next Page
Loading...
