9. LOADING FACTORY DEFAULTS
You change the system codes and program settings to the factory settings. If you
apply this process, all codes and settings are cleared. You can change the codes by
using master program, you can change the codes and adjustments by using the
engineer program to the factory settings.
!!! WARNING !!!
The user is responsible for all changing process.
You can return to the factory settings by allowing from <10 06>. If you do not allow,
the resetting process can not be done. In order to open the resetting allows;
Enter the engineer program.
1. Press long to 4 (program) button until you hear long "beep" sound
2. Enter 4 numbered engineer code. (Factory value: 9999)
Reset allows are entered and allowed.
a) For LED Keypad,
1. Enter to the <10 06>.
2. Select the 1 or 2.
b) For LCD Keypad,
1. 1-PANEL SETTINGS→GENERAL SETTINGS→RESET PERMISSION
2. Select the 1 or 2.
The settings in <10 06> are selected as the factory settings for both of options.
9.1. Changing The Codes To The Factory Settings
Enter the Master or Engineer program.
1. Press long to 4 (program) button until you hear long "beep" sound
2. Enter the master or engineer code (Master: 1234, Engineer: 9999)
Enter to the resetting address.
a) For LED Keypad,
1. Enter the <10 04>.
2. Select the option 1. (The option of code resetting)
3. Press the "" key
b) For LCD Keypad,
1. 1-PANEL SETTINGS→GENERAL SETTINGS→RESET TYPE
2. Select the option 1. (The option of code resetting)
3. Press the "" key
To Next Page
Loading...
