Address 60 02. < IP >
Display for settings:
LED 60 02 (wait)
LCD MODULES→WIRELESS MODULE→SUPERVISORY INT. (wait)
Change for settings:
LED 60 02 <Value> "√"
LCD MODULES→WIRELESS MODULE→SUPERVISORY INT.
<Value> HOUR
Shown/Entered value: <Value>, Value between 1...255 as hour
Factory default: 6
Example: To set supervisory interval 24 do.
60 02 2 4 √
8.8.3. Zone Expansion Module
The module is connect to panel for expanding the zone number.
1.option=Enabled/Disabled
Address 61 01. < IP >
Display for settings:
LED 61 01 (wait)
LCD MODULES→EXP ZONE SETTING→EXP ZONE SETTING (wait)
Change for settings:
LED 61 01 <Value> "√"
LCD MODULES→EXP ZONE SETTING→EXP ZONE SETTING
<Value>
Shown/Entered value: <Value>, 1 options enable/disable only
Factory default: Disable
Example: To enable Zone Module do.
61 01 1 (Turn on) √
8.9 PROGRAMMING ADDRESSES
To Next Page
Loading...
