7.1 ENTERING/EXITTING FROM THE PROGRAMS
Entering to The Installer Program
a) Press 4(Program) key until hearing long "beep" sound
b) Enter 4 digit Installer code. (Factory default : 9999)
If you entered to the program, Program light turns on the LED keypad. Ready light
flickers. "INSTALLER MENU" appears on the LCD keypad screen. Otherwise, please
press "x" (Exit) key and try again
Entering to Master Program
a) Press 4(Program) key until hearing long "beep" sound
b) Enter 4 digit Master code. (Factory default : 1234)
If you entered to the program, Program light turns on the LED keypad. Ready light
flickers. "MASTER MENU" appears on the LCD keypad screen. Otherwise, please
press "x" (Exit) key and try again.
Exiting from The Programming Mode
Until hearing the long beep sound press long to "x" (Exit) key. The program light
disappears for LED keypad, for LCD it changes to main menu.
Note: After programming, if you do not do anything the panel changes from
"program" mode to normal mode in 3 minutes.
7.2. CHANGING THE CODES
Press long to "√"(Password) key. Enter the old code, enter the new code, enter the
new code again and press to "√" key. (PC access and Duress codes can not be
changed by this shortcut.)
Example:
Let’s change the master code from the factory default (1234) to "9876".
"√" (press long) 1234 9876 9876 "√"
old new new again
8. THE PROGRAMMING DETAILS
In this section, the programming states are shown by "Installer Program" <IP> and
"Master Program" <MP>. The addresses that can be entered can be seen below
table.
Symboling: For all the guide, the symboling is below.
4(Program<press long>): Press long to 4 key until the long beep heard.
8: Press to 8 key.
HHMM: HH is hour and MM is minute. For example press 1,2,5,9
keys for 12:59 time.
(2 turn on) (3 turn off): 2.light-option will be selected(turned on), 3.light-option will
be not selected(turned off)
The value that can be entered to an address is 1 of 3 types; number, one option,
multiple option.
While explaining each adjustment issue, title, what adjusting, the possible values and
programming please are written. For seeing the adjustment value in the address, the
necessary procedures for LCD and LED were written, then for changing the adjusted
value , the necessary procedure, for LCD and LED were written and there is a
sample for each keypad. The indication with LED shows the button which must press
To Next Page
Loading...
