You can open and close permission of PC access and Phone. If you wrongly enter
code 5 times, the panel automatically closes.
The meaning o these selections in these addresses are below;
1.option=Phone Remote Control Enable/Disable
2.option=PC Remote Control Enable/Disable
Address 15 01. < IP, MP >
Display for settings:
LED 15 01 (wait)
LCD PANEL SETTINGS→REMOTE ACCES→REMAC OPTIONS (wait)
Change for settings:
LED 15 01 <Value> "√"
LCD PANEL SETTINGS→REMOTE ACCES→REMAC OPTIONS
<Value> "√"
Shown/Entered value: <Value>, 1...2 multi selection from above list
Factory default: Nothing selected
Example: To enable remote control (phone) do.
15 01 1 (turn on) √
Answer Ring Count
When the panel called by the user, the panel waits "the value in this address" times
ringing, then answers. You can use 15 02 address as 2 different types.
1. As ring count by giving a value between 1 to 20
2. As "Double call" adjustment by giving it 0 (zero) value.
Address 15 02. < IP, MP >
Display for settings:
LED 15 02 (wait)
LCD PANEL SETTINGS→REMOTE ACCES→RING COUNT (wait)
Change for settings:
LED 15 02 <Sayı> "√"
LCD PANEL SETTINGS→REMOTE ACCES→RING COUNT
<Sayı> "√"
Shown/Entered value: <Sayı>, 0...20 arası çalma sayısı
Factory default: 5
Example: Çalma sayısını 10 yapmak.
15 02 10 √
Double Call
If the phone line is used for a couple of device and the phone line is allocated to the
other device normally (like fax machine), opening the line by the panel before the
other device can be obtained by using this feature. You can use 15 02 two kinds of
type using between 1 and 20 values or using double calling with 0 value.
The procedure for open double calling:
i. Call to panel with 2 calling and shut the phone.
ii. Call to panel between 10 and 60 second again.
Panel opens the end of first calling.
Address 15 02. < IP, MP >
Display for settings:
LED 15 02 (wait)
LCD PANEL SETTINGS→REMOTE ACCES→RING COUNT (wait)
Change for settings:
LED 15 02 <Value=0> "√"
LCD PANEL SETTINGS→REMOTE ACCES→RING COUNT
To Next Page
Loading...
