Telit Wireless Solutions ME310G1 - Page 675

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 675 of 1039 2021-09-23
Not Subject to NDA
1÷maxBytes
:
maxBytes is the maximum number
of bytes that can be sent and it is
reported by the test command
<Rai>
integer
N/A
RAI (Release Assistance
Indication) configuration
Values:
1
:
Set RAI to: "No further uplink or downlink data
transmission subsequent to this transmission"
2
:
Set RAI to: "Only a single downlink data
transmission and no further uplink data
transmissions subsequent to this
transmission"
It's possible to use #SSENDEXT only if the connection was opened
by #SD, else the modem returns an error.
All special characters are sent like a generic byte. For example,
0x08 is not interpreted as a BS (BackSpace) but it is simply sent
through the socket.
RAI (Release Assistance Indication) is supported in NB-IoT only,
otherwise is ignored.
AT#SSENDEXT=?
Test command returns the range of supported values for parameters
<connId>, <bytesToSend> and <Rai>.