ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev. 11 Page 676 of 1039 2021-09-23
Open the socket in command mode:
AT#SD=1,0,<port>,"IP address",0,0,1
OK
Enter the command specifying total number of bytes as second parameter:
AT#SSENDEXT=1,256
> .............................. ; Terminal echo of bytes sent is displayed here
OK
All possible bytes (from 0x00 to 0xFF) are sent on the socket as generic
bytes.
To Next Page
Loading...
