Telit Wireless Solutions ME910G1 - ATH - Hang UpDisconnect the Current Call

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 110 of 545 2020-04-15
3.1.5.2. ATH - Hang Up/Disconnect the Current Call
This execution command hangs up/disconnects the current voice/data call or dial-up.
ITU-T Recommendation V.25 ter
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
ATH
When a data call or a dial-up is active the device is in on-line mode hence, to execute
ATH command the device must be previously turned in command mode using the
escape sequence or, if &D1 option is active, tying Low the DTR pin.