Telit Wireless Solutions ME910G1 - DTE - Modem Interface Control; ATE - Command Echo

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 94 of 545 2020-04-15
3.1.4. DTE - Modem Interface Control
3.1.4.1. ATE - Command Echo
This command allows to enable or disable the command echo.
ITU-T Recommendation V.25 ter
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
ATE[<n>]
The execution command allows to enable/disable the command echo.
Parameter:
Name
Type
Default
Description
<n>
integer
1
Configuration value
Values:
0
:
disables command echo
1
:
enables command echo, hence command sent to the device are echoed back
to the DTE before the response is given.
If parameter is omitted, the command has the same behavior of ATE0