EasyManua.ls Logo

Telit Wireless Solutions ME910G1 - AT&C - Data Carrier Detect (DCD) Control

Telit Wireless Solutions ME910G1
545 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 98 of 545 2020-04-15
3.1.4.5. AT&C - Data Carrier Detect (DCD) Control
This set command controls the DCD output behavior of the AT commands serial port.
ITU-T Recommendation V25 ter
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT&C[<n>]
Parameter:
Name
Type
Default
Description
<n>
integer
1
DCD output behavior
Values:
0
:
DCD remains always High
1
:
DCD follows the Carrier detect status: if carrier is detected DCD goes High,
otherwise DCD is Low
2
:
DCD is always High except for 1 sec "wink" when a data call is disconnected
If parameter is omitted, the command has the same behavior of AT&C0

Table of Contents

Other manuals for Telit Wireless Solutions ME910G1

Related product manuals