Telit Wireless Solutions ME910G1 - AT#SSLO - Restore a SSL Socket after a

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 469 of 545 2020-04-15
3.17.5. AT#SSLO - Restore a SSL Socket after a +++
This command restores a SSL connection (online mode) suspended by an escape sequence (+++).
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#SSLO=<SSId>
This command restores a SSL connection (online mode) suspended by an escape sequence (+++).
After the connection restore, the CONNECT message is printed. Please note that this is possible
even if the connection has been started in command mode (#SSLD with <connMode>=1).
Parameter:
Name
Type
Default
Description
<SSId>
integer
1
Secure Socket Identifier
Value:
1
:
only one socket is available.
If secure socket has not be enabled through #SSLEN command, only test command can
be used.
Before opening a SSL connection, the PDP context must have been activated by
AT#SGACT=X,1.
If an error occurs during reconnection the socket cannot be reconnected, then a new
connection has to be done.
AT#SSLO=?
Test command returns the range of supported values for all the parameters:
#SSLO: (1)