Telit Wireless Solutions ME910G1 - AT#SSLRECV - Read Data from a SSL Socket

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 472 of 545 2020-04-15
3.17.8. AT#SSLRECV - Read Data from a SSL Socket
This command reads data from a SSL socket.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT#SSLRECV=<SSId>,<MaxNumByte>[,<Timeout>]
Set command allows to receive data, arrived through a connected secure socket. Data has been
buffered and not read yet.
Parameters:
Name
Type
Default
Description
<SSId>
integer
1
secure socket identifier
Value:
1
:
until now only one SSL socket is supported
<MaxNumByte>
integer
N/A
maximum number of bytes to read
Value:
1÷1000
:
maximum number of bytes to read
<Timeout>
integer
100
time-out in 100 ms units
Value:
1÷5000
:
hundreds of ms
Additional info:
If data are received, the device responds:
#SSLRECV: NumByteRead
...(Data read)...
OK
If no data are received, the device responds:
#SSLRECV: 0
TIMEOUT
OK
If the remote host closes the connection, the device responds:
#SSLRECV: 0
DISCONNECTED
OK