Telit Wireless Solutions ME910G1 - AT#PING - Send PING Request

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 409 of 545 2020-04-15
3.13.30. AT#PING - Send PING Request
This command is used to send Ping Echo Request.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Other
No
-
2
AT#PING=<IPaddr>[,<retryNum>[,<len>[,<timeout>[,<ttl>[,<pdpId>]]]]]
Execution command is used to send Ping Echo Request messages and to receive the
corresponding Echo Reply. Before sending PING Request the PDP context must be activated by
#SGACT command.
Once the single Echo Reply message is received, a string like that is displayed:
#PING: <replyId>,<Ip Address>,<replyTime>,<ttl>
Parameters:
Name
Type
Default
Description
<IPaddr>
string
-
address of the remote host, string type. This parameter can
be either:
- any valid IP address in the format: "xxx.xxx.xxx.xxx"
- any host name to be solved with a DNS query
<retryNum>
integer
4
the number of Ping Echo Request to send
Value:
1÷64
:
Ping Echo Request number
<len>
integer
32
the length of Ping Echo Request message
Value:
32÷1460
:
Ping Echo Request length
<timeout>
integer
50
the timeout, in 100 ms units, waiting a single Echo Reply
Value:
1÷600
:
timeout, in 100 ms units
<ttl>
integer
128
time to live
Value:
1÷255
:
time to live
<pdpId>
integer
-
specifies a PDP context definition. Use the
AT+CGDCONT=? test command to get the range of the
supported values. Refer to additional info section for default
value.
Additional info:
<pdpId> default value.
The default value of this parameter depends on the software customization as shown in the
following table.