EasyManua.ls Logo

Telit Wireless Solutions ME910G1 - AT+CGAUTH - Define PDP Context Authentication Parameters

Telit Wireless Solutions ME910G1
545 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 341 of 545 2020-04-15
3.12.6. AT+CGAUTH - Define PDP Context Authentication Parameters
This command allows the TE to specify authentication parameters for a PDP context.
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT+CGAUTH=<cid>,<auth_type>,<username>,<password>
Set command allows the TE to specify authentication parameters for a PDP context identified by
the (local) context identification parameter <cid>, used during the PDP context activation and the
PDP context modification procedures.
Parameters:
Name
Type
Default
Description
<cid>
integer
-
specifies a particular PDP context definition, see the
+CGDCONT command.
<auth_type>
integer
0
selects the authentication protocol used for this PDP
context.
Values:
0
:
no authentication
1
:
PAP authentication
2
:
CHAP authentication
<username>
string
-
User name for access to the IP network
<password>
string
-
Password for access to the IP network
AT+CGAUTH?
Read command returns the PDP authentication parameters, excluding <password>, for every
defined PDP context, in the format:
+CGAUTH: <cid1>,< auth_type1 >,<username1><CR><LF>
...
+CGAUTH:<cidmax>,<auth_typemax >,<usernamemax><CR><LF>
AT+CGAUTH=?
Test command reports the supported range of values for parameters <cid>, <auth_type> and the
maximum lengths for parameters <username> and <password>.

Table of Contents

Other manuals for Telit Wireless Solutions ME910G1

Related product manuals