Telit Wireless Solutions ME910G1 - ATS2 - Escape Character

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 84 of 545 2020-04-15
3.1.3.3. ATS2 - Escape Character
The command manages the ASCII character used as escape character.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
ATS2=<char>
Set command sets the ASCII character to be used as escape character.
Parameter:
Name
Type
Default
Description
<char>
integer
43
escape character decimal ASCII
Value:
0÷255
:
factory default value is '+'
The escape sequence consists of three escape characters preceded and followed by n
ms of idle (see S12 to set n).
ATS2?
Read command returns the current value of S2 parameter.
The format of the numbers in output is always 3 digits, left-filled with 0s.