Telit Wireless Solutions ME910G1 - Ciot Optimization; AT+CCIOTOPT - Ciot Optimization Configuration

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 484 of 545 2020-04-15
CIoT Optimization
3.18.1. AT+CCIOTOPT - CIoT Optimization Configuration
This command controls CIoT EPS (Cellular Internet of Things, Evolved Packet System) optimizations.
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT+CCIOTOPT=[<n>[,<supportedUEopt>[,<preferredUEopt>]]]
The set command controls which CIoT EPS optimizations the UE indicates as supported and
preferred in the ATTACH REQUEST and TRACKING AREA UPDATE REQUEST messages. The
command also allows reporting of the CIoT EPS optimizations that are supported by the network;
an unsolicited result code is used to indicate the supported CIoT EPS optimizations by the network:
+CCIOTOPTI: <supportedNetworkopt>
For parameter meaning refer to Unsolicited code values.
Parameters:
Name
Type
Default
Description
<n>
integer
0
enables or disables reporting of unsolicited
result code +CCIOTOPTI:
Values:
0
:
Disable reporting
1
:
Enable reporting
3
:
Disable reporting and reset the parameters for CIoT EPS
optimization to the default values
<supportedUEopt>
integer
3
indicates the UE's support for CIoT EPS
optimizations.
Values:
0
:
No support
1
:
Support for control plane CIoT EPS optimization
2
:
Support for user plane CIoT EPS optimization
3
:
Support for both control plane CIoT EPS optimization and user
plane CIoT EPS optimization (default value for modules
supporting NBIoT technology)
<preferredUEopt>
integer
0
indicates the UE's preference for CIoT
EPS optimizations.
Values:
0
:
No preference
1
:
Preference for control plane CIoT EPS optimization
2
:
Preference for user plane CIoT EPS optimization