Telit Wireless Solutions ME910G1 - AT+CSODCP - Sending of Originating Data Via the Control Plane

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 354 of 545 2020-04-15
3.12.14. AT+CSODCP - Sending of Originating Data Via the Control Plane
The set command is used by the TE to transmit data over control plane to network via MT. Context identifier
<cid> is used to link the data to particular context.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT+CSODCP=<cid>,<cpdataLength>,<cpdata>,<RAI>[,<typeOfUserData>]
Parameters:
Name
Type
Default
Description
<cid>
integer
-
specifies a particular PDP context or EPS bearer
context definition. The <cid> parameter is local to the
TE-MT interface and identifies the PDP or EPS
bearer contexts which have been setup via AT
command (see the +CGDCONT and +CGDSCONT
commands)
<cpdataLength>
integer
-
indicates the number of octets of the <cpdata>
information element. When there is no data to
transmit, the value shall be set to zero.
<cpdata>
string
-
is a string of octets. Contains the user data container
contents. When there is no data to transmit, the
<cpdata> shall be an empty string (""). This
parameter shall not be subject to conventional
character conversion as per +CSCS. The coding
format of the user data container and the maximum
length of <cpdata> are implementation specific.
<RAI>
integer
0
indicates the value of the release assistance
indication
Values:
0
:
no information available
1
:
the MT expects that exchange of data will be completed with the
transmission of the ESM DATA TRANSPORT message
2
:
the MT expects that exchange of data will be completed with the
receipt of an ESM DATA TRANSPORT Message
<typeOfUserData>
integer
0
indicates whether the user data that is transmitted is
regular or exceptional
Values:
0
:
regular data
1
:
exception data
AT+CSODCP=?
Test command reports the supported range of values for parameters: <cid>,<cpdataLength>,
<RAI> and <typeOfUserData>.