EasyManua.ls Logo

Telit Wireless Solutions ME910G1 - AT&D - Data Terminal Ready (DTR) Control

Telit Wireless Solutions ME910G1
545 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 99 of 545 2020-04-15
3.1.4.6. AT&D - Data Terminal Ready (DTR) Control
This set command configures the behavior of the module according to the DTR control line transitions (RS232).
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
AT&D[<n>]
Parameter:
Name
Type
Default
Description
<n>
integer
0
defines the module behavior according to the DTR control
line transitions
Values:
0
:
module ignores DTR control line transitions
1
:
when the module is connected, the high to low transition of DTR line sets the
module in command mode, the current connection is not closed
2
:
when the module is connected, the high to low transition of DTR line sets the
module in command mode and the current connection is closed
3
:
C108/1 operation is enabled
4
:
C108/1 operation is disabled
If AT&D2 has been issued, and the DTR line has been tied Low, auto-answering is
inhibited and it is possible to answer only issuing command ATA.
If parameter is omitted, the command has the same behavior of AT&D0.

Table of Contents

Other manuals for Telit Wireless Solutions ME910G1

Related product manuals