Telit Wireless Solutions ME910G1 - AT#BND - Select Band

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 132 of 545 2020-04-15
3.2.14. AT#BND - Select Band
This command selects RF bands
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Auto
No
-
2
AT#BND=<band>[,<UMTS_band>[,<LTE_band>[,<TDSCDMA_band>[,<LTE_band_over_64>]]]]
Set command selects the current GSM and LTE (CATM and NBIot) bands. CATM and NBIot bands
are set to the same <LTE_band> and <LTE_band_over_64> values.
Parameters:
Name
Type
Default
Description
<band>
integer
-
GSM band selection.
For 4G only products:
<band>
/
0
dummy parameter
For 4G/2G products supporting GSM 900 MHz,
DCS 1800 MHz, PCS 1900 MHz and GSM 850
MHz:
<band>
GSM bands
0
GSM 900MHz + DCS 1800MHz
1
GSM 900MHz + PCS 1900MHz
2
GSM 850MHz + DCS 1800MHz
3
GSM 850MHz + PCS 1900MHz
4
GSM 900MHz + DCS 1800MHz +
PCS 1900MHz
5
GSM 900MHz + DCS 1800MHz +
PCS 1900MHz + GSM 850MHz
<UMTS_band>
integer
0
this parameter is used for backward compatibility.
Value:
0
:
for both 4G only and 4G/2G products.
<LTE_band>
integer
N/A
indicates the LTE supported bands expressed as
the sum of Band number (1+2+8 ...) calculated as
shown in the table (mask of 32 bits):
Band number
Band i
1
B1
2
B2
4
B3
8
B4
...
...
(2exp(i-1))
Bi