Telit Wireless Solutions ME910G1 - AT+CSDH - Show Text Mode Parameters

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 220 of 545 2020-04-15
3.5.6. AT+CSDH - Show Text Mode Parameters
This command controls whether detailed header information is shown in text mode.
3GPP TS 27.005
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
Specific profile
No
-
2
AT+CSDH=[<show>]
Set command controls whether detailed header information is shown in text mode (AT+CMGF=1)
result codes.
Parameter:
Name
Type
Default
Description
<show>
integer
0
control the display of the result codes.
Values:
0
:
see Additional info section
1
:
show the values in result codes
Additional info:
If <show>=0
do not show header values defined in commands +CSCA and +CSMP (<sca>,<tosca>,
<fo>, <vp>, <pid> and <dcs>) nor <length>, <toda> or <tooa> in +CMT, +CMGL,
+CMGR result codes for SMS-DELIVERs and SMS-SUBMITs in text mode.
For SMS-COMMANDs in +CMGR result code do not show <pid>, <mn>, <da>, <toda>,
<length> or <cdata>
AT+CSDH?
Read command reports the current setting in the format:
+CSDH: <show>
AT+CSDH=?
Test command reports the supported range of values for parameter <show>.