EasyManua.ls Logo

Telit Wireless Solutions ME910G1 - GNSS Receiver; ATGPSP - GNSS Controller Power Management

Telit Wireless Solutions ME910G1
545 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 527 of 545 2020-04-15
3.23.2. GNSS Receiver
3.23.2.1. AT$GPSP - GNSS Controller Power Management
This command powers on/off GNSS controller .
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Other
No
-
2
AT$GPSP=<status>
The set command manages the power-up/power-down of the GNSS controller.
Parameter:
Name
Type
Default
Description
<status>
string
0
indicates the power status that has to be set.
Values:
0
:
GNSS controller is powered down
1
:
GNSS controller is powered up
Power up clears GPS memory and then starts the GPS receiver. GPS data cleaning is
performed on the base of the current value of the <reset_type> parameter (see $GPSR).
GPS operation mode is performed on the base of the current values of $GPSSLSR
configuration (see $GPSSLSR).
AT$GPSP?
The read command reports the current value of the <status> parameter, in the format:
$GPSP: <status>
AT$GPSP=?
The test command reports the supported values range for parameter <status>.
<status> value is stored through $GPSSAV command.
GNSS controller is powered down
AT$GPSP=0
OK

Table of Contents

Other manuals for Telit Wireless Solutions ME910G1

Related product manuals