Telit Wireless Solutions ME910G1 - ATS7 - Connection Completion Time-Out

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 88 of 545 2020-04-15
3.1.3.7. ATS7 - Connection Completion Time-Out
This set command specifies the amount of time that the DCE shall allow between either answering a call
(automatically or by the ATA command) or completion of signaling of call addressing information to network
(dialing), and establishment of a connection with the remote DCE. If no connection is established during this
time, the DCE disconnects from the line and returns a result code indicating the cause of the disconnection.
ITU-T Recommendation V.25 ter
3GPP TS 27.007
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
Specific profile
No
-
2
ATS7=<tout>
Parameter:
Name
Type
Default
Description
<tout>
integer
60
defines time interval expressed in seconds
Value:
1÷255
:
available range
ATS7?
Read command returns the current value of S7 parameter.
The format of the numbers in output is always 3 digits, left-filled with 0s.