Telit Wireless Solutions ME910G1 - AT#ECMD - ECM Shutdown

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 537 of 545 2020-04-15
3.24.1.2. AT#ECMD - ECM Shutdown
This command is used to shutdown an Ethernet Control Model (ECM) session.
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Not required
No
No
-
2
AT#ECMD=<Did>
Parameter:
Name
Type
Default
Description
<Did>
integer
N/A
Device id, currently limited to 0 (only one device)
Value:
0
:
Device id (currently limited to only one device)
To make active the command the module must be rebooted.
AT#ECMD?
Read command returns the session state in the following format:
#ECM: <Did>,<State>
OK
Additional info:
Parameter returned by the read command and not described in the previous sections.
Name
Type
Default
Description
<State>
integer
0
State of Ethernet Control Model (ECM) session
Values:
0
:
disabled
1
:
enable
AT#ECMD=?
Test command returns the range of supported values for <Did>.
Modules supporting the commands
ME310G1
-WW
ME910G1
-WW
ML865G1
-WW