Telit Wireless Solutions ME910G1 - AT+CMGL - List Messages

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 232 of 545 2020-04-15
3.5.12. AT+CMGL - List Messages
This command is used to list the messages.
3GPP TS 27.005
3GPP TS 23.040
3GPP TS 23.038
SIM Presence
Setting saved
Can be aborted
MAX timeout
SELINT
Required
No
No
-
2
AT+CMGL[=<stat>]
Execution command reports the list of all the messages with status value <stat> stored into
<memr> message storage (<memr> is the message storage for read and delete SMs as last
settings of command +CPMS).
Parameter:
Name
Type
Default
Description
<stat>
mixed
-
<stat> parameter type and the command output depend on the
last settings of the +CMGF command (message format to be
used). There are two modes:
• PDU mode
• Text mode
See the following Additional info sections.
Additional info:
When message format is PDU mode, the <stat> parameter is:
Name
Type
Default
Description
<stat>
integer
N/A
status value
Values:
0
:
new message
1
:
read message
2
:
stored message not sent yet
3
:
stored message already sent
4
:
all messages
In case of PDU mode the representation format (see +CMGF) is:
+CMGL: <index>,<stat>,<alpha>,<length><CR><LF><pdu>[<CR><LF>
+CMGL: <index>,<stat>,<alpha>,<length><CR><LF><pdu>[...]]