Telit Wireless Solutions ME910G1 - Page 199

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 199 of 545 2020-04-15
Unsolicited fields:
Name
Type
Description
<cmdTerminateValue>
integer
is defined as <cmdType> + terminate offset. Terminate
offset = 100
<cmdControlResponse>
integer
response of the SIM/USIM device
Values:
150
:
SMS control response
160
:
call/SS/USSD response
<Result>
integer
identify the result of the Call or SMS control performed by
SIM/USIM device
Values:
0
:
Call/SMS not allowed
1
:
Call/SMS allowed
2
:
Call/SMS allowed with modification
<alphaIdentifier>
string
optional text provided by the SIM/USIM device in ASCII
format
<Number>
string
Called number, Service Center Address or SS String in
ASCII format
<MODestAddr>
string
MO destination address in ASCII format
The settings are saved on user profile and available on following reboot. SIM/USIM
Toolkit activation/deactivation is only performed at power on according to the saved
setting.
If AT#ENS=1, the <mode> parameter is set to 2.
Just one instance at a time, the one which first issued AT#STIA=<mode> (with <mode>
not equal to 0), is allowed to issue SAT/USAT commands, and this is valid till the same
instance issues AT#STIA=0. After reboot, SAT/USAT can be used on another instance.
AT#STIA?
Read command can be used to get information about the SAT/USAT interface. The message
format is:
#STIA: <state>,<mode>,<timeout>,<SatProfile>
Additional info:
Returned parameters.
Name
Type
Default
Description
<state>
integer
0
state of the sending of the SET UP MENU
proactive command (37)