Telit Wireless Solutions ME910G1 - Page 298

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 298 of 545 2020-04-15
<mode>=2, the timings of STAT_LED pin are:
• not registered: always ON
• registered in idle: blinking 1 s ON and 2 s OFF
• registered in idle with power saving: blinking time depends on network condition
to minimize power consumption
<mode>=4, the timings of STAT_LED pin are:
• not registered: blinking 0,5 s ON and 0,5 s OFF
• registered in idle: blinking 300 ms ON and 2,7 s OFF
• registered in idle with power saving: blinking time depends on network condition
to minimize power consumption
AT#SLED?
Read command returns the STAT_LED pin current setting, in the format:
#SLED: <mode>,<onDuration>,<offDuration>
AT#SLED=?
Test command returns the range of available values for parameters <mode>, <onDuration> and
<offDuration>.
The setting is saved using the #SLEDSAV command.