Telit Wireless Solutions ME910G1 - Page 348

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 348 of 545 2020-04-15
+CGEREP: <mode>,<bfr>
AT+CGEREP=?
Test command reports the supported range of values for the +CGEREP command parameters.
Here are some examples:
•
A network request for PDP context activation occurred when the TA was unable to
report it to the TE with a +CRING unsolicited result code and was automatically
rejected.
+CGEV: REJECT <PDP_type>, <PDP_addr>
•
The network has requested a context reactivation. The <cid> that was used to
reactivate the context is provided if known to TA.
+CGEV: NW REACT <PDP_type>, <PDP_addr>, [<cid>]
•
The network has forced a context deactivation. The <cid> that was used to activate
the context is provided if known to TA.
+CGEV: NW_DEACT <PDP_type>, <PDP_addr>, [<cid>]
•
The mobile equipment has forced a PS detach. This implies that all active contexts
have been deactivated. These are not reported separately.
+CGEV: ME_DETACH
•
The network has forced a PS detach. This implies that all active contexts have been
deactivated. These are not reported separately.
+CGEV: NW_DETACH