Telit Wireless Solutions ME910G1 - Page 357

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 357 of 545 2020-04-15
In LTE network, default PDP context (<cid>=1) is activated by piggybacking on LTE
attach procedure and maintained until detached from network. This command with
<cid>=1 is just binding or unbinding application to the default PDP context.
If the unsolicited result code for obtaining IP address was enabled (urcmode value) using
#SGACTCFG command, on start up and due to USB enumeration timing the unsolicited
may not appear, user should manually use +CGPADDR command to see the IP address.
AT#SGACT?
Read command returns the state of all the contexts that have been defined in the format:
#SGACT: <cid
1
>,<stat
1
><CR><LF>
...
#SGACT: <cid
n
>,<stat
n
>
Each row in the read command's answer is optional.
AT#SGACT=?
Test command reports the range for the parameters <cid> and <stat>.