Telit Wireless Solutions ME910G1 - Page 386

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 386 of 545 2020-04-15
AT#SSENDEXT=?
Test command returns the range of supported values for parameters <connId>, <bytesToSend>
and <Rai>.
Open the socket in command mode:
AT#SD=1,0,<port>,"IP address",0,0,1
OK
Enter the command specifying total number of bytes as second parameter:
AT#SSENDEXT=1,256
> .............................. ; Terminal echo of bytes sent is displayed here
OK
All possible bytes (from 0x00 to 0xFF) are sent on the socket as generic bytes.