Telit Wireless Solutions ME910G1 - Page 487

ME310G1/ME910G1/ML865G1 AT Commands Reference Guide
80617ST10991A Rev.4 Page 487 of 545 2020-04-15
AT#CCIOTOPT=?
Test command reports the range for the parameter in the format:
#CCIOTOPT: (list of supported <bitmask> values)
Example of setting a value for <bitmask>.
•
AT#CCIOTOPT=0137
OK
In this example, <bitmask>, expressed in four hex digit, is 0137= 0000 0001 0011
0111
The mapping is:
Last Significant
Byte
of <bitmask>
1
EMM_CP_CIOT
Control Plane CIoT
optimizations
1
EMM_UP_CIOT
User Plane CIoT optimizations
1
EMM_S1_U
S1-U data transfer
0
EMM_ER_WITHOUT_PDN
EMM registered w/o PDN
connection
1
EMM_HC_CP_CIOT
RoHC
1
EMM_SMS_ONLY
0
EMM_PNB_CP_CIOT
Preferred network behavior CP
CIoT
0
EMM_PNB_UP_CIOT
Preferred network behavior UP
CIoT
Most Significant
Byte
of <bitmask>
1
EMM_EPCO_CIOT
Enable extended protocol
configuration options
Bit 1 ... Bit 7
Not used