Texas Instruments TI-84 Plus Guide Book

Chapter 5: Polar Graphing 147
Defining and Editing Polar Equations
Defining and Editing Polar EquationsDefining and Editing Polar Equations
Defining and Editing Polar Equations
To define or edit a polar equation, follow the steps in Chapter 3 for defining a function or
editing a function. The independent variable in a polar equation is q. In Pol graphing
mode, you can enter the polar variable q in either of two ways.
• Press „.
• Press ƒ
[q].
Selecting and Deselecting Polar Equations
Selecting and Deselecting Polar EquationsSelecting and Deselecting Polar Equations
Selecting and Deselecting Polar Equations
The TI-84 Plus graphs only the selected polar equations. In the Y= editor, a polar
equation is selected when the
= sign is highlighted. You may select any or all of the
equations.
To change the selection status, move the cursor onto the
= sign, and then press Í.
Setting Window Variables
Setting Window VariablesSetting Window Variables
Setting Window Variables
To display the window variable values, press p. These variables define the viewing
window. The values below are defaults for Pol graphing in Radian angle mode.
qmin=0
Smallest q value to evaluate
qmax=6.2831853... Largest q value to evaluate (2p)
qstep=.1308996... Increment between q values (pà24)
Xmin=L10
Smallest X value to be displayed

Texas Instruments TI-84 Plus Specifications

General

Battery type	AAA
Power source	Battery
Number of batteries supported	4
Type	Graphing
Cover	No
Form factor	Pocket
Control type	Buttons
Product color	Black
USB port	Yes
USB 2.0 ports quantity	1
Digits	- digits
Display number of lines	8 lines
Display number of characters	16
RAM capacity	0.024 MB
ROM capacity	0.480 MB
Storage media type	-