Chapter 16: Programming 427
Creating and Deleting Programs
Creating and Deleting ProgramsCreating and Deleting Programs
Creating and Deleting Programs
What Is a Program?
What Is a Program?What Is a Program?
What Is a Program?
A program is a set of one or more command lines. Each line contains one or more
instructions. When you execute a program, the TI-84 Plus performs each instruction on
each command line in the same order in which you entered them. The number and size
of programs that the TI-84 Plus can store is limited only by available memory.
Creating a New Program
Creating a New ProgramCreating a New Program
Creating a New Program
To create a new program, follow these steps.
1. Press | to display the
PRGM NEW menu.
8. Press Í to paste
prgmCYLINDER to the current
cursor location. (If
CYLINDER is not item 1 on your
PRGM EXEC menu, move the cursor to CYLINDER
before you press Í.)
9. Press Í to execute the program. Enter
1.5 for
the radius, and then press Í. Enter
3 for the
height, and then press Í. The text
VOLUME IS,
the value of
V, and Done are displayed.
Repeat steps 7 through 9 and enter different
values for
R and H.
To Next Page
Loading...
