Chapter 9: Split Screen 214
If stat plots are turned on, the plots are shown along with the x-y plots in graphs. Press
y 0 to make the table portion of the split screen active and to display the list data.
Press † or } to highlight a value you want to edit, and then enter a new value directly in
the table to overwrite the previous value. Press ~ repeatedly to display each column of
data (both table and list data).
Split-screen display with both x-y plots and stat plots
Some screens are never displayed as split screens. For example, if you press z in
Horiz or G-T mode, the mode screen is displayed as a full screen. If you then press a key
that displays either half of a split screen, such as r, the split screen returns.
When you press a key or key combination in either
Horiz or G-T mode, the cursor is
placed in the half of the display for which that key applies. For example, if you press
r, the cursor is placed in the half in which the graph is displayed. If you press
y0, the cursor is placed in the half in which the table is displayed.
The TI-84 Plus will remain in split-screen mode until you change back to
Full screen
mode.
To Next Page
Loading...
Need help?
General
