8-30 4262930-Rev A
CUTTING UNIT
8
Figure 8-45
6. Install counterweight (15) using screws (13) and
washers (14).
7. Lubricate grease fitting (16) with grease that meets
or exceeds NLGI Grade 2 LB specifications. Clean
grease fittings before lubricating and apply grease to
the fittings with a hand grease gun only. Pump the
gun slowly until a slight amount of pressure is felt,
then stop—do not over-grease. Do not use
compressed air gun.
8. Install grass shield. (See “Grass Shield” on
page 8-21.)
9. Install cutting unit front roller. (See “Cutting Unit Front
Roller” on page 8-33.)
10. Install cutting unit to mower. (See “Cutting Unit” on
page 8-20.)
TN0905
16
15
13 14
13 14
To Next Page
Loading...
