Textron Jacobsen HR-5111 - Page 236

5-72 4203780 First Edition
HYDROSTATIC POWER TRAIN
5
Figure 5-77
10. Press the drive axle/brake disk assembly (14) into
the reducer housing (13).
Figure 5-78
11. Install spacer (18), retaining ring (17), washer (16),
and gear (15) on drive axle (19).
Figure 5-79
12. Clean the mating surfaces (20 and 21) of the
differential housing (28) and reducer housing (23).
Make sure the surfaces are dry. Apply Loctite Ultra
Blue gasket material in a continuous bead around the
mating surface, making sure to go around each hole.
13. Install the dowel sleeves (22) in the holes as shown.
14. Install the reducer housing (23) on the differential
housing (28) using four screws (24 and 25). Tighten
screws to 37 lb-ft (51 N·m).
15. Install the brake caliper assembly (27) using two
screws (29) and nuts (26). Tighten nuts to 37 lb-ft
(51 N·m).
TN1926
14
13
TN1927
15
16
17
18
19
TN1928
29
22
22
20
25
26
27
21
24
23
28