Textron Jacobsen HR-5111 - Page 336

7-10 4203780 First Edition
STEERING
7
Figure 7-16
13. Support the steering valve (15).
14. Remove four nuts (16), lock washers (17), and flat
washers (18). Remove the operator assist handle
bracket (13).
15. Remove steering valve (15) from console (14).
Figure 7-17
Installation Notes
• Install the steering valve by reversing the order of
removal.
• When installing the tilt lever (19), screw the lever in
until tight, and then back the lever off to the position
shown. Hold the lever and tighten the jam nuts (20).
• Check hydraulic oil level. Add oil as needed.
• Start the machine and check for hydraulic leaks and
cylinder operation. Repair as necessary.
TN1741
13
17
18
15
16
14
TN1743
19
20