4-98 4203781 First Edition
ELECTRICAL
4
Figure 4-90
• Make sure wing mow enable switch and light switch
are installed as shown in Figure 4-90 (arrow
indicates rear of mower).
Figure 4-91
• Make sure 4WD switch is installed as shown in
Figure 4-91 (arrow indicates rear of mower).
Reverse Kick-Out Switch
Removal and Installation
See Figure 4-92.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Disconnect the negative (–) battery cable at the
battery.
Figure 4-92
NOTE
Label all wires before disconnecting to ensure correct
installation.
3. Disconnect wire connector (5).
4. Remove two nuts (1), lock washers (2), flat washers
(3), and screws (4).
5. Remove reverse kick-out switch (6).
Installation Notes
• Install the reverse kick-out switch by reversing the
order of removal.
• Adjust the reverse kick-out switch. (See “Reverse
Kick-Out Switch Adjustment” on page 5-29.)
TN1966
TN1967
TN2181
6
5
1 2 3 4