3-16 4203781 First Edition
ENGINE
3
Figure 3-26
9. Remove two flange nuts (12) and screws (20).
10. Remove throttle lever mounting bracket (21), and
disassemble lock nut (13) and screw (19), lock nut
(14) and carriage bolt (18), friction plate (15), two
friction discs (16) and throttle handle (17) from
throttle lever mounting bracket.
Figure 3-27
11. Remove nut (25), washer (26), and screw (27) to
disconnect the throttle cable (23) from the governor
throttle lever (24).
12. Loosen nuts (22) and remove throttle cable.
Installation Notes
• Install the throttle cable and control lever by reversing
the order of removal.
• When replacing a worn or broken throttle cable, route
the same as the old cable.
• After replacing, follow the adjustment procedure.
(See “Throttle Cable” on page 3-5.)
Fuel Filter
Removal and Installation
See Figures 3-28 and 3-29.
!
CAUTION
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Allow the engine to cool completely before servicing.
3. Disconnect the battery negative (–) cable at the
battery.
Figure 3-28
4. Turn the fuel outlet hose shutoff valve (1) clockwise
until valve bottoms lightly. Valve is located on the
bottom of the fuel tank.
5. Thoroughly clean the fuel filter cover and area
surrounding the fuel filter.
TN2298
13
12
14
15
16
17
19
TN2298
16
18
20
21
TN2172
27 25
23
26
24
22
Diesel fuel is highly flammable. Handle with care.
Use an approved container with a spout that will
fit inside the fuel filler neck. Avoid using
unapproved containers to transport fuel. Keep all
fuel containers clean and closed when not in use.
TN1788
1
To Next Page
Loading...
