ELECTRICAL
673831-Rev A 4-71
4
Engine Temperature Sensor
Removal and Installation
See Figure 4-55.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Raise the hood.
3. Disconnect the negative (–) battery cable at the
battery.
Figure 4-55
Label all wires before disconnecting to ensure correct
installation.
4. Remove nut (2) and disconnect wire (3) from the
engine temperature sensor (1).
5. Remove engine temperature sensor (1).
Installation Notes
• Install the engine temperature sensor by reversing
the order of removal.
• Apply Teflon tape to the threads of the engine
temperature sensor before installing.
Fuel Solenoid
Removal and Installation
See Figure 4-56.
1. Park the mower safely. (See “Park Mower Safely” on
page 1-6.)
2. Raise the hood.
3. Disconnect the negative (–) battery cable at the
battery.
Figure 4-56
Label all wires before disconnecting to ensure correct
installation.
4. Disconnect wire connector (1).
5. Remove two socket head screws (2).
6. Remove fuel solenoid (3).
Installation Note
Install the fuel solenoid by reversing the order of removal.
Engine coolant is hot and under pressure! Allow
the cooling system to cool completely before
performing service.
Required Materials
Telfon
®
Tape
To Next Page
Loading...
Need help?
General
