HYDROSTATIC POWER TRAIN
673831-Rev A 5-5
5
Hydraulic Service Tools
The hydraulic service tools listed here can be obtained
from K-Line Industries at http://klineind.com.
Portable In-Line Filter
Part Number JAC5097
When hydraulic components fail internally, debris from
the failed component can spread throughout the
hydraulic system and cause additional damage.
This situation can be magnified when dealing with a
closed-loop traction system, where oil is not filtered. In
the event of a traction system component failure, it is
recommended that all traction system components be
disassembled and cleaned, or filtered using a portable
in-line filter available through your Jacobsen Dealer. The
portable in-line filter should also be used when testing
hydraulic systems or after replacing a failed component.
Always install the in-line filter so oil flows through
the filter before entering a component. Once filtering
has begun, never reverse the flow of oil, or debris will
re-enter the system.
Digital Hydraulic Tester
Part Number AT40031
Features
• Flow up to 100 gpm (379 lpm)
• Pressure up to 6000 psi (414 bar)
• Temperature up to 250° F (120° C)
• Digital display for flow and temperature
• Analog display for pressure
• Flow accuracy 1% of full scale
Hydraulic Flow Meter
Part Number AT40002
Features
• Glycerin filled pressure gauge
• Precision needle-type load valve
• 4–40 gpm (15–15 lpm) flow range
• Pressure up to 5000 psi (345 bar)
• -12 port size
To Next Page
Loading...
Need help?
General
