ELECTRICAL
673831-Rev A 4-37
4
Optional Work Lights Circuit—Theory of Operation
Unswitched Power Circuit
Unswitched power is available from the battery positive
terminal to the 3-way distribution block.
Unswitched power is available from the 3-way distribution
block to the following:
• 30-amp fuse (F3)
• 15-amp fuse (F4)
Unswitched power is available from 30-amp fuse (F3)
output terminal to the ignition relay (K1) terminal 30.
Unswitched power is available from 15-amp fuse (F4)
output terminal to the following components:
• Ignition switch terminal 6
• LDU Display terminal 1-01
Switched Power Circuit (Green)
When the key switch (SW1) is turned to the run position,
voltage is provided from key switch terminal 4 to ignition
relay (K1) terminal 86, energizing the relay and to MCU
(U1) terminal 1-02.
With the ignition relay (K1) energized, switched power is
provided from ignition relay terminal 87 to the following
components:
• Light switch (SW6) terminal 2
Work Light Circuit
When the light switch is placed in the on position, voltage
is provided to the three work lights, turning on the lights.
To Next Page
Loading...
Need help?
General
