2-6 673831-Rev A
SPECIFICATIONS AND GENERAL INFORMATION
2
Steering
Cutting Units
Repair Specifications
Gear Pump—Rear Cover-to-Pump Body Bolt Torque lb-ft (N·m) 33 (45)
Lift Valve—Coil Nut Torque
lb-ft (N·m) 10 (13.5)
Lift Valve—Relief Valve Torque
lb-ft (N·m) 24–26 (32.5–35.3)
Lift Valve—Check Valve Torque
lb-ft (N·m) 19–21 (25.8–28.5)
Lift Valve—Rear Side Port “T” Fitting Torque
lb-ft (N·m) 60 (81.4)
Reel Valve—Coil Nut Torque
lb-ft (N·m) 10 (13.5)
Reel Valve—Flow Control Torque
lb-ft (N·m) 24–26 (32.5–35.3)
Reel Valve—Relief Valve Torque
lb-ft (N·m) 24–26 (32.5–35.3)
Hydraulic Oil Tank Capacity
gal (L) 7.5 (28.4)
Lift Cylinder Rod Nut Torque
lb-ft (N·m) 50 (67.8)
Test and Adjustment Specifications
Steering System Leakage Test—Cylinder Leakage pt (L) Zero–Nominal Amount
Rear Axle Alignment Toe-In Measurement
(4WD Option)
in. (mm) 0.0625 (1.6)
Rear Axle Spindle Arm-to-Axle Stop Measurement
(4WD Option)
in. (mm) 0.0625 to 0.125 (1.6 to 3.2)
Repair Specifications
Steering Wheel Nut lb-ft (N·m) 25–30 (34–41)
Steering Column-to-Steering Unit Screw Torque
lb-ft (N·m) 15 (20)
Steering Cylinder to-Steering Arm Torque
(3WD Option)
lb-ft (N·m) 103 (140)
Steering Cylinder Ball Joint-to-Steering Arm Torque
(4WD Option)
lb-ft (N·m) 40-55 (55–75)
Tie Rod Ball Joint-to-Steering Arm Torque
(4WD Option)
lb-ft (N·m) 30–35 (40–47)
Checks and Adjustments Specifications
Cutting Unit Down Pressure Adjustment—Initial Ball
Joint-to-Rod Cross Pin Length
in. (mm) 8.94 ± 0.062 (227 ± 2)
Reel Bearing Pre-Load
in. (mm) 0.040 (1.0)
Bedknife-to-Reel Clearance
in. (mm) 0.001–0.003 (0.025–0.076)
Bedknife Front Face Height
in. (mm) 0.060 (1.5)
Bedknife Front Face Height (Minimum)
in. (mm) 0.035 (0.9)
Bedknife Front Face Angle
degrees 5
Bedknife Top Face Angle (Rear Relief)
degrees 8–10
Reel Blade Relief Angle
degrees 45
To Next Page
Loading...
