TOHATSU MFS 2 Service Manual

1-8
4st 2/2.5/3.5 2007
6) Rigging
1. Check that clamp bracket is fixed securely to hull.
2. Check location of anti-ventilation plate relative to boat
bottom, and, if necessary, adjust to prevent decrease in
performance force and engine overheating.
a
5) Fuel Tank and Fuel Line
1. Check that fuel tank contains sufficient amount of gasoline,
fuel line is connected and is free of leaks.
CAUTION
Since this is a 4 stroke engine model, do
not use fuel mixed with engine oil. Use of
fuel mixed with engine oil will cause engine
trouble.
7) Inspection of Tilt Stopper
1. Fully tilt up the outboard motor 1, lock with the tilt stopper
2, and then check that the holding mechanism functions
normally.
2
1
Test-run to determine the best installation
height.
a 30 - 50 mm ( 1.2 - 2.0 in )
Location of anti-ventilation plate : Standard value
30 - 50 mm (1.2 - 2.0in) from boat bottom
Service Information
MFS2sec01070524.qxd07.5.243:05 PM  ページ8

TOHATSU MFS 2 Specifications

General

Brand	TOHATSU
Model	MFS 2
Category	Engine
Language	English