TOHATSU MFS 2 Service Manual

3-12
Maintenance
4st 2/2.5/3.5 2007
4. Check spark plug gap a. Replace if the gap is over
specified value. Adjust gap if it is out of specified range.
5. Install spark plug, fully hand-tighten b, and then use plug
wrench to tighten to specified torque c.
11) Inspection of Spark Plug
1. Remove plug cap and then spark plug.
Spark Plug Gap a : Standard
0.8 - 0.9 mm (0.031- 0.035 in)
Spark Plug :
18 N･m (13 lb･ft) [1.8 kgf･m]
2
a
1
2
2. Use spark plug cleaner or wire brush to clean spark plug
electrode 1. Replace if necessary.
3. Check electrode 1 for corrosion or excessive build up of
carbon, and washer 2 for damage. Replace if necessary.
c
b
SOC
OIL-COMP.
GM
SOCSOC
Specified Spark Plug :
DCPR6E[NGK]
Functional Limit :
1.0 mm (0.039 in)
MFS2sec03070524.qxd07.5.243:16 PM  ページ12

TOHATSU MFS 2 Specifications

General

Brand	TOHATSU
Model	MFS 2
Category	Engine
Language	English