TOHATSU MFS 2 Service Manual

3Washer
3-6
Maintenance
4st 2/2.5/3.5 2007
3. Engine Oil Replacement Procedure
Use of engine oil containing dirt or water can significantly
shorten the lives of rotating and sliding parts of engine.
Replacement of Engine Oil :
1. Stop the engine and set outboard motor straight ahead
and vertical.
2. Remove top cowl and then oil filler cap 1.
3. Place drain oil pan below drain bolt 2.
4. Remove drain bolt 2 to drain oil.
5. Tighten drain bolt 2 to specified torque.
6) Replacement of Engine Oil
1. Oil Level
300cm
3
250cm
3
2. Oil Specification
-20 -10 0 10 20 30 40
10W – 40
10W – 30
Engine Oil
Ambient air temperature
°C
Upper Limit (Center)
Lower Limit
Engine Oil :
4 Stroke Engine Oil
API : SF, SG, SH
SAE : 10W-30, 10W-40
NMMA : FC-W Certified 10W-30
Quantity of Engine Oil :
300cm
3
（10 fl.oz）
OIL
Use oil with viscosity that is suited to ambient air
temperature of the operating region.
Apply oil to washer 3 of drain bolt 2.
3
2
Drain Bolt :
18N･m (13 lb･ft) [1.8kgf･m]
2
1
Do not reuse.
MFS2sec03070524.qxd07.5.243:16 PM  ページ6

TOHATSU MFS 2 Specifications

General

Brand	TOHATSU
Model	MFS 2
Category	Engine
Language	English