TOHATSU MFS 2 Service Manual

2-14
Service Data
4st 2/2.5/3.5 2007
7.Sealant Application Locations
Loctite
Three
Bond
Loctite
Three
Bond
Konishi
Shin
etsu
Silicones
271 1342 518 1107
G１７
Centax
L2
FM-
531
LM-
902
KS-
64
Camshaft
●
Area of bearings, cams and gears
Lifter
●
Cam sliding face, push rod insertion area
Push Rod
●
Both ends
Push Rod Plate
●
Push rod pass hole end face
Rocker Arm
●
Push rod sliding area, pivot sliding area
Rocker Arm Pivot
●
Locker arm sliding face
Valves (IN, EX)
●
Shaft area, stem head area
Valve Spring
●
Whole area of the part
Retainer, Cotter
●
Whole area of the part
Valve Stem Seal (IN, EX）
●
Lip area and interior
Slinger Pin
●
Inner face of pin insertion hole
O-Ring (Filler Cap)
●
Whole area of the part
Cylinder Liner
●
Inner wall
Piston
●
Ring grooves and circumference
Piston Rings
●
Whole area of the part
Piston Pins
●
Outer circumference
Connecting Rod
●
Inner surface of big and small ends
Connecting Rod Cap
●
Inner surface
Crankshaft
●
Sliding area, and areas of bearings and
gears
Oil Seal
(Crankshaft)
●
Lip area
Thrust Plate
(Crankshaft)
●
Whole area of the part
Crank Case-Cylinder Mating Face
●
Oil Level Gauge
●
Outer circumference
●
Outer circumference
●
Lip area
Oil Seals (2 pcs. In the crank case
head)
●
Lip area
Engine Base Gasket
●
Both faces
Throttle Drum
●
Inner surface
Throttle Opener
●
Inner surface
Throttle Rod
●
Both ends hole insertion area
●
Spark plug insertion area
●
High tension cord area
Chuo Yuka
Spark Plug Cap
Oil Seal
Cylinder Block/
Crankcase
Intake
Manifold
Electrical
Parts
Oil Pan
Remarks
Applied to
Gear Oil 4-stroke Engine Oil Silicon Grease Teflon Grease Waterproof Grease Low Temperature Resistant Lithium Grease Adheasive Gasket Seal Agent Screw Lock Agent
Engine
LIT OBM TEF SOC
MFS2sec02070524.qxd07.5.243:12 PM  ページ14

TOHATSU MFS 2 Specifications

General

Brand	TOHATSU
Model	MFS 2
Category	Engine
Language	English