4. SYSTEM MODE (For Service Persons and System Administrators) EO13-33005
4.8 RAM Clear
4- 71
• Value after parameter clear
Parameter Value
Feed amount fine adjustment (PC) +0.0mm
Print tone fine adjustment (PC) +0step
Strip position fine adjustment (PC) +0.0mm
Feed amount fine adjustment (Key) +0.0mm
Print tone fine adjustment (Key) +0step
Strip position fine adjustment (Key) +0.0mm
X-coordinate fine adjustment (Key) +0.0mm
Transmissive sensor manual threshold fine adjustment
value
1.4V
Reflective sensor manual threshold fine adjustment value 1.0V
Print command language TPCL
Print type (BATCH/STRIP) NONE
(Print depending on the sensor used)
Strip sensor sensitivity adjustment AUTO
Character code PC-850
Font zero “0” (without slash)
QM type ENGLISH LCD language
JA type JAPANESE
Control code AUTO
EURO font code B0H
Automatic print head check for broken dots OFF
MaxiCode specification TYPE1
Head division AUTO1
Print head check for broken dots after cover close OFF
Resume printing after broken dots error OFF
Feed to top of feed after cover close OFF
B-SP series compatibility mode OFF
Linerless OFF
XML OFF
Beep volume 1
Auto power-off timing 120min
Power save mode timing 3sec
LCD backlight off timing 3sec
To Next Page
Loading...
Need help?
General