4. SYSTEM MODE (For Service Persons and System Administrators) EO13-33005
4. SYSTEM MODE (For Service Persons and System Administrators)
4- 1
4. SYSTEM MODE (For Service Persons and System
administrators)
In this mode, self-test and parameter settings are performed. Described below is the key operation
procedure in system mode.
System mode consists of ten main menus: Self-diagnostic test, Mode setting, Parameter setting, Printer
parameter fine adjustment, Test print, Sensor adjustment, RAM clear, Interface Setting and Basic setting.
Each menu is used for the following purposes:
• To check and print the system status, the Maintenance Counter, and the Print Head Element.
• To set the parameters for the communication with the host computer, and the printer functions such as
the language for LCD message, Feed key function, etc.
• To make fine adjustment related to the media issue.
• To perform a test print for checking print quality.
• To check the status of the sensors and to set the threshold of the media sensor for pre-printed media.
• To perform a Maintenance Counter clear and Parameter clear.
• To set the Interface setting
• To set the Basic setting
To Next Page
Loading...
Need help?
General