4. SYSTEM MODE (For Service Persons and System Administrators) EO13-33005
4.5 Printer Parameter Fine Adjustment
4- 45
4.5.4 Print Tone Fine Adjustment (TONE ADJ.)
This setting finely adjusts the print tone against the value automatically set.
Notes:
1. When the [FEED] key is pressed, the menu moves in the opposite direction from when the [PAUSE]
key is pressed.
2. When the [PAUSE] key is pressed while the [FEED] key is held down, or when the [POWER] key is
pressed for 3 seconds or more, the display returns to the system mode menu (ADJUST SET).
3. When the [PAUSE] key or [FEED] key is pressed for 0.5 seconds or more during this fine adjustment
setting, repeat mode is enabled and the key pressed is repeatedly entered.
4. The change in the fine adjustment value becomes effective when the [POWER] key is pressed after
setting, then stored in the backup memory.
5. The printer is controlled by the total amount determined by this command and the Position Fine
Adjustment command sent from the PC. However, the maximum value is ±30 step.
6. The factory default value is +0step.
TONE ADJ. -30
TONE ADJ. -29
TONE ADJ. +0
TONE ADJ +29
TONE ADJ +30
Darker
Lighter
Standard
[PAUSE]
[FEED]
To Next Page
Loading...
Need help?
General